Twingo Mingo the F4RT powered Twingo GT

[Robx1r]

I'm starting to wonder will these fit in the twingo

 

[Adey]

they look.... err very wide! just slap one in for the driver passenger can use the jesus handles

 

[Aldo]

I sized up Corbeau Clubsports for my GT, which are fairly small, and they were a snug fit. Shoulder bits close to touching in the centre.

 

[Robx1r]

The wise and sensible thing to do would be to measure it

 

[Robx1r]

Wellllllll......... F*CK. Twingo at the widest from Pillar to Pillar is 125cm and the seats are 66 each.now I'm not a rocket scientist or a maths whizz but there's a difference between 132 and 125.. hmmmmm

 

[Mark_L]

Oh, but they'll look good in @DaveL485 's 21T...

 

[andybond]

Wellllllll......... F*CK. Twingo at the widest from Pillar to Pillar is 125cm and the seats are 66 each.now I'm not a rocket scientist or a maths whizz but there's a difference between 132 and 125.. hmmmmm

 

[DaveL485]

Oh, but they'll look good in @DaveL485 's 21T...

 

[Robx1r]

Maybe @DaveL485 but unfortunally they are not cheap

 

[DaveL485]

Maybe @DaveL485 but unfortunally they are not cheap

Go on, shock me.

 

[Robx1r]

They are standing me a cool £1100

 

[DaveL485]

They are standing me a cool £1100

I'm not actually too surprised at that, but, unfortunately, out of my price range right now as I'm saving for a Mk4 Clio EDC!

 

[Robx1r]

Ah I'm not giving up on it just because a tape says no. A lot of big things going into a small car require work arounds

 

[Brigsy]

Cut the car down the middle and add 100mm in, or fit one seat and a skinny passenger seat

 

[Aldo]

Or..... the passenger seat 300mm further back than the drivers seat

 

[Robx1r]

Yeah the plan is mount the driver seat and have a passenger behind. As I want to keep this road legal (ish) they will be on sliders,

 

[Robx1r]

Had a start with modifying the intake, tried to go the tasty route of a hole, but looks like it's best if I just cut a chunk out of it

 

[Brigsy]

Might be worth using one of these fittings?

Pardon our interruption...

If no good id be tempted to get a fitting tigged onto the top and block that end.

 

[Robx1r]

Nooope grinder was too short, so hacksaw and then a copious amount of sanding to tidy

 

[Robx1r]

Flywheel starter alternator and a few other bits