part number again

[Steve-V6-D61]

Just looked though the part listings but cant find the part number for the fixings for the inner front arch liner to the bumper undertray, for phase 2 2004

there 3 each side at the bottom of the arch linner at the front of the car.

Any info would be good.

Thanks

Steve

 

[Jamesv6]

I'm guessing item 5 and 6

BLT RLX M6X100-20
Part number : 7703008162
NUT ME
Part number : 7705096019

 

[Steve-V6-D61]

Hi James

Seem the parts book only shows a Phase 1 inner arch in picture form, the attached is a diagram from the the Phase 2 bodywork manual and you can see the 3 fixing

I think they will be plastic pins.

 

[Williams]

Hi Steve.. they are torx screws. Same size head as the ones used to hold the 'D' panel along the front. 25mm long, gauge would be 3mm by the looks of it. each has a washer for it too. All in black. I hope this helps.

 

[RUSSO]

Steve, from memory 2 bottom fixing screws and 3 push fitting 'christmas tree' fittings.
Just changed light washers
Phil

 

[Williams]

Phil, without doubt 3 screws along the front into the 'D' panel bud. Large xmas tree fixing to the top of the inner arch, can't recall exactly on the rear or else where.

 

[RUSSO]

Shaun, might be right ; 2 or 3 torque and the rest push fit!!!!!!
Sure I had 2 in bumper and about 3 in inner arch!!!!!!!!!!!!!!!
P.S. Steve youv'e chose one brill colour for that vee, can't wait to see it in the flesh mate :approve:

 

[Williams]

Shaun, might be right ; 2 or 3 torque and the rest push fit!!!!!!
Sure I had 2 in bumper and about 3 in inner arch!!!!!!!!!!!!!!!
P.S. Steve youv'e chose one brill colour for that vee, can't wait to see it in the flesh mate :approve:

LOL.. Still think you'll find its 3 along the front.. I could pop outside to the garage and check, but its too late.

Agreed on the colour of this car though, its gorgeous!! I wonder why it was never an option in the UK..??

 

[Jamesv6]

Diagrams are old most times. The part numbers changed up a few times to those I listed above.

 

[Steve-V6-D61]

THANKS GUYS

GREAT HELP

STEVE [smilie=boohoo.gif]

 

[Jamesv6]

Of course the result of not fitting these 3 screws.

 

[Steve-V6-D61]

That picture is that a example of GDI workmanship, if so "HOW BIZARRE"

 

[Jamesv6]

Did you buy my old ones from them?

 

[Steve-V6-D61]

Ah they were yours James, yes brought them with a pop rivetted repair patch over the holes, now the patch is cut down to the hole size and glued in place.

 

[Jamesv6]

They couldn't even patch up their fook ups properly LMAO. Good job Steve. :approve:

 

[Ali]

FLOL!!!! Thats made my night.

 

[Fred]

mine too LOL!

 

[Big Iain]

GDi superb!!!