Passenger window falling out of runner

[Neilos626]

Hi all,

my passenger window gets about half way down then falls out of the runner on the inside of the door, meaning I can't fully open the window.

Is there any way I can adjust the window alignment so that it stays flush in the runner at all time?





I'm thinking the only place I can make an adjustment is on the carrier but I can't see how.

Thanks

 

[Neal R19]

there should be a little black plastic doobrey attached to the back edge of the window, this should clip into the vertical seal at the back of the door.

This is the only thing that keeps the window in the runners.

 

[Neilos626]

Thanks Neal, the doberry is still attached and initially i thought this was the problem as it had torn a chunk out of the window rbber and kept jumping out at this point.

However I have today replaced the window rubber and it still keeps jumping out, the runner inside the door seems to bow so as the window reaches the middle, it is no linger in the runner. This in turn causes the window to lurch forward and pop out. It's a real PITA.

Not sure from looking at it that there is much else I can do with it, maybe replace the black dooberry, but how easy/hard will that be?

 

[Larry]

i cant remember what the runners look like in that car but if its like the clio there should be a kind of rubber/plastic guide in the channel that the window travels along

 

[cvslawrence]

Is the runner in the first pic attatched? If that is loose, the window will just push it out when you roll it down.