Bleed Nipple problem

[s_o_n_y]

Hello and yes i have done it...

I was gonna replace the brakefluid and i only manage to bleed frh side. When i was going to bleed flh side the bleednipple did brake :/

So i have drilled the most of it out but i need to know the size of the nipple. If i look at apracing page you can find one that is M10x1,0

Is this right ? I also need to know this to drill the last out with right milimeter on the drill.

Please help !

Regards Robin

 

[Budgie895]

Don't quote Me, but if its a 10mm bleed nipple you'll need to drill it out at 8.5mm,
I think! Unless you already know that! :rollseyes:

 

[RUSSO]

Just make sure you run a M10x1mm (fine thread) tap down as the standard M10 thread should be a1.5mm pitch and will mess things up big style!!!!Also I'd like to know if they are a taper thread, something to bear in mind.

 

[s_o_n_y]

That im already know

But im not sure if it is the ;10x1,0 nipple :rollseyes:

 

[s_o_n_y]

FYI it is M10x1,0mm for Bleed Nipple