There is more to life with TurboRenault.co.uk

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

idle

  1. L

    21 Turbo R21 turbo starting and idle problems

    Hello from Finland! My 1988 21 turbo is having starting and idle problems and I haven't found out the reason for these problems. I have already asked these same questions in Facebook 21turbo owners club page and now I try here too. Problem is: Starting is slow, it takes few seconds (maybe 3-7...
  2. Miguel

    5 GT Turbo Unstable rough idle

    I rebuilt the engine some months ago, rebuilt the carb too. But since the rebuilt the engine runs unstable at idle. I have to keep rpm above 2000rpm so the engine keeps running. When I try to reduce the idle it enters into a cycle where it goes up to 2200-2000rpm and down to 1600-1400 rpm and...
  3. jpmad4it

    Megane R26 coil pack order please?? Rough idle & engine vibration after spark plug change

    Hi all, Please can anyone confirm the coil pack order on the Megane R26? I had my spark plugs changed last week but I'm not sure the mechanic took notice of the order of the coil pack. The car is now vibrating like mad and I can feel it through all the pedals, even when idle. The higher the...
  4. probecomp

    Megane Engine vibration on idle R26

    Hi guys, I've been chasing this problem for a while now, with no luck. The symptom is engine vibration on idle, when the engine gets warmer (when it's cold, you can't really feel it). Happens only on idle and the vibrations sort of go in waves (from less to more and back again) rather than...
  5. Mark Davis

    5 GT Turbo R5 bogging at idle

    Anyone here good with the 32DIS carb ? Check out vid. This is happening a lot recently. Car warms up and idles perfectly at mid 14s, no bother. Now after a run (more noticeable after a bit of boost) if I pull up to a junction or set of lights idle afrs hit 11s 12s as shown in video. It then...
  6. Brigsy

    Clio Clio 1.5 dci rough idle

    Anybody have experience with the 1.5 dci lumps?? (Well i know a few of you will have :D) Just bought a clio dci 65 for a bargain price today. The issue i have is rough idle - but no warning lights on dash, pulls well with plenty of power - not bellowing out smoke and starts ok from cold. Not...
  7. Ash Robinson

    5 GT Turbo Rough Idle - low rev splutter/judder

    Hi, I recently had a uprated fuel pump fitted and think it may be the cause, its got a rough idle now and seems like it wants to cut out, and low revs under 2k it has a judder when I try to accelerate, could this be because the fuel/air mixture would be changed now due to uprated high pressure...
  8. Ryanbrown

    Megane Rough idle

    when my car is idle it runs not consistent and vibrates, car runs fine when drive and reved, any ideas? Sensor? Ps sorry for beeb busy body posting all time but this forum is only one that I seem to get answers from!
  9. D

    renault 19 1721cc idle speed valve

    hi my renault races at around 2000 rpm when started and after driving for 10 minutes drops down to around 1000 rpm. any ideas ? thanks
  10. 2

    21 Turbo misfire at idle when hot

    Hi all, here i am with another issue that has been bugging me for a few weeks and i'm still not 100% sure what's about. When i start the engine, cold, it runs at first try and very smooth. I can drive it either normally or flat out that everything works as it should. However, if i stop the...
  11. Rob

    Finally cleaned idle control valve

    Does any one no if this is from a 21 or off another renault of sorts doesn't seem to be same as the others ?
  12. danny4da

    idle speed

    What should a standard 5 be idling at?
  13. gangles1987

    Uprated Camshaft Idle And Start Up Questions

    not had my car long (21 turbo) I know a little bit of its history it had some minor headwork about 4 years ago had the head ported and polished different valve springs and a camshaft fitted I believe it was a piper fast road cam different exhaust and a recon turbo ever since then the idle has...
  14. R

    idle is to fast

    Hi all, got a19 16v which idles at 1200 rpm what could the cause be .thanks
  15. W

    F7P idle

    Hi I need advice on why the idle wont drop below 2 1/2 after its been above 5 when hot. Then turn it off and back on again and it's fine? Other then that its running fine. Help please
  16. DigitalBix

    High Idle RPM

    Hi My PH1 19 16v revs are a bit high plus they increase when the steering is used more than say half a turn, then the revs settle down again.Some days it does settle around 950 rpm other days can be 1100 - 1200 rpm. I,ve taken the ICV off and checked that it rotates ok and is clean. also...
  17. M

    Hunting on idle

    Hi, I've changed spark plugs, new ht leads, got rid of spark plug extenders, fitted new dizzy cap and rotar arm, cleaned carb and also Idle screws but..... My 5 is still hunting quite badly on idle. Is there a restrictor in one of the small pipes? Any pics of which pipe? Any other ideas...
  18. tobin

    Rough idle - MAF sensor?

    Hi everyone. I'm trying to diagnose/fix a rough idle and dismal fuel economy (about 15mpg or 15L/100km) on my 1996 Renault 19 1.8L 8V. Previously replaced a cold air intake hose which was broken for some time (undiscovered). In trying to diagnose the problem, I tried checking what I believe...
  19. H

    megane f7r lumpy idle , stalling , missfire , overfuelling

    97 megane coupe 2.0 16v f7r sudden onset problem stalls when coming to rest and changing gear. at startup will not idle without throttle. will idle rough then revs will drop to 0 after 30/40 seconds will keep running but is very lumpy and revs fluctuate between 1000 and <500...
  20. Bird

    Roughth idle after clean icv

    Hey today decided to sort the rough idle out on my 19 ! So started with the ICV and TB . Cleaning them both out with carb clean rags and Cotten buds "both were spanking clean .... Then moved on to inlet manifold. Took all rubber vacuum pipes off manifold and cleaned them out . Disconnected all...
Back
Top