Megane Braking Fault.

[Mark_L]

Have a Braking fault on my wife's Megane 2 175dci.

I backed out of a gateway and thd Braking fault came on. Previously had the abs light on.

Bought a genuine sensor from RPD, found the rh front sensor was cut through at the track rod. Also had blown the dash 10A abs fuse.

Tried a different uch,

Abs doesn't work. All feeds and earth's are present at the abs pump, the sensors are all reading through my cheap module. Except 1 reads at 1 per km/H where as the other 3 read at 1 per 10 km/h. Odd. Swapped both front sensors which hasn't changed anything.
It's still reading the same.

Driving me mad and mot next week please help!

@Red21

 

[Mark_L]

@Red21

Do you know if a 12/13% variation in the load % is too much?

Thanks

 

[Red21]

If that is from the lowest percentage figure to the highest either at no load or whilst loaded it's ok, but if that's the difference from unloaded to loaded there is potential issue.
I haven't forgotten about getting the diag information but that outage last week seems to have caused some form of cascade failure in a sever and any link to the outside world is sporadic to a point that trying to do my job is almost impossible.

 

[Mark_L]

If that is from the lowest percentage figure to the highest either at no load or whilst loaded it's ok, but if that's the difference from unloaded to loaded there is potential issue.
I haven't forgotten about getting the diag information but that outage last week seems to have caused some form of cascade failure in a sever and any link to the outside world is sporadic to a point that trying to do my job is almost impossible.

OK, no problem, it seems the same, around 12/13% under load or not no load goes from 28 to 41%,
Under load goes from 44 to 61%.

Did you see the 2 videos I put up? First one no load second under load?

Thanks for all your help much appreciated.