1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. This section contains the archived boards. They should be read only. If you want a thread resurrecting please message admin and we can move into the live section
    Dismiss Notice
  3. Hi ! Thanks for taking a look at turboRenault.co.uk If you found this site useful , please consider registering. It will only take a second and you are able to register with your facebook details if you prefer ! :) Thanks Admin

Renix units

Discussion in 'Modifying' started by read6737, Jul 14, 2012.

Discuss Renix units in the Modifying area at TurboRenault.co.uk.

  1. read6737

    read6737 Well-Known Member

    Can a RE 036 be fitted in place of the RE 009?
    If so does you need any changes or additions?

    What are the modifications needed to replace the 009 or 036 with the RE299?
     
  2. phildini

    phildini Well-Known Member

    Who told you about the re299?

    You need to replace part of the loom and replace the tdc with another unit sensor for it to work properly. :wink:
     
  3. read6737

    read6737 Well-Known Member

    I read about the 299 from reading a few French sites.
    I went looking as I knew that I did not have a 009 on the Cleveland, So I just went and had a look and it is a RE299.
    Looks like it has been on the car for a while.
     
  4. mrdini

    mrdini Well-Known Member

    An 036 fitted to a Gordini turbo/ non Le car turbo car runs and drives but not without fault , you would need to make changes to the Gordini loom I guess to create the slight diff in looms from Gordini to lecar spec as the 2 wiring diagrams show the changes, my car fitted with 036 ran and drove but when you give it some beans there was massive backfiring and juddering on boost, which I'm not sure of the cause? Shame as I wanted the 036 built in rev limiter.
     
  5. phildini

    phildini Well-Known Member

    Well I have plenty of 009's :wink:
     
  6. read6737

    read6737 Well-Known Member

    Does any one have the wiring changes that are needed to install
    the RX299 in place of the 009 or 036.
    Just in case I need to swap back.

    Phildini how much will you sell a 009 for ?
     
  7. phildini

    phildini Well-Known Member

    Loom and module is expensive from renault dont know if it's worth it.
     
  8. mrdini

    mrdini Well-Known Member

    Does anyone know the curve figures for the re299 by any chance? Would like to compare to the other modules. Thanks
     
  9. phildini

    phildini Well-Known Member

    Patience MrDini, when you get something in your head you always want it NOW!!! Told you I will find it for you....... One day :wink:
     
  10. mrdini

    mrdini Well-Known Member

    Phil , that's a classic m8
     
Verification:
reCAPTCHA verification is loading. Please refresh the page if it does not load.
Draft saved Draft deleted